"IP " CNS Standards Search Result |
CNS 7555
- English Version SlIP-on Welding Steel Pipe Flanges (16 kgf/㎠) 滑入熔接式鋼製管凸緣(16 kgf/㎠) - 英文版 |
|
|
CNS 14115
- English Version Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equIPment 電氣照明與類似設備射頻擾動特性之限制值與量測法 - 英文版 |
|
|
CNS 794
- English Version Basic Dimensions of 63 kgf/㎠ Steel PIPe Flanges 鋼製管凸緣基準尺度(63 kgf/㎠) - 英文版 |
|
|
CNS 8117
- English Version ShIPs' Light Load Derrick Gooseneck Brackets 船用輕載吊桿鵝頸架 - 英文版 |
|
|
CNS 12789
- English Version Roller sports equIPment - Roller skates 輪式運動器材-輪式溜冰鞋 - 英文版 |
Translated |
|
CNS 14810
- English Version Methods of test for holiday detection in pIPeline coatings 管線被覆缺陷(針孔)測定法 - 英文版 |
|
|
CNS 15207-1
- English Version Road vehicles − Component test methods for electrical disturbances from narrowband radiated electromagnetic energy − Part 1: General princIPles and terminology 道路車輛-窄頻輻射電磁能量之電擾動組件試驗法-第1 部:通則及用語 - 英文版 |
|
|
CNS 2692
- English Version Pliers and nIPpers - Pliers for gripping and manipulating 夾鉗與剪鉗-滑節轉樞夾鉗(鯉魚鉗) - 英文版 |
|
|
CNS 16016-2
- English Version Plastics pIPing systems for hot and cold water installations − Polypropylene (PP) − Part 1: General 冷熱水裝置用塑膠管配管系統-聚丙烯(PP)-第2部:管 - 英文版 |
|
|
CNS 12491-3
- English Version Graphical Symbols for Use on Electrical and Electronic EquIPment (Movement,Action,Run,Adjustment) 電機電子設備用圖符號(移動,動作,運轉,調整) - 英文版 |
|
|
CNS 15852-1
- English Version Thermoplastics pIPes, fittings and assemblies for the conveyance of fluids − Determination of the resistance to internal pressure − Part 1: General method 流體輸送用熱塑性塑膠管、管件及組合件-耐內壓力測定-第1 部:一般方法 - 英文版 |
|
|
CNS 8577
- English Version Glossary of Terms Relating to Electric EquIPment for Automobiles (Sound Signalling Device System) 汽車用電器零件詞彙(音響警告系統) - 英文版 |
|
|
CNS 15068
- English Version Internet protocol, version 6 (IPv6) specification 網際網路協定第6版(IPv6)規格 - 英文版 |
|
|
CNS 2334
- English Version Unplasticized polyvinyl chloride (PVC-U) pIPe fittings for water supply 自來水用硬質聚氯乙烯塑膠管件 - 英文版 |
|
|
CNS 12491-4
- English Version Graphical Symbols for Use on Electrical and Electronic EquIPment (Alarm,Signal,Filter) 電機電子設備用圖符號(警報,信號,濾波器) - 英文版 |
|
|
CNS 15620-3
- English Version Insulation coordination for equIPment within low-voltage system – Part 3: Use of coating, potting or moulding for protection against pollution 低電壓系統下設備之絕緣協調-第3 部:用於污染防護之塗裝、封裝或壓塑 - 英文版 |
|
|
CNS 12497
- English Version Diving equIPment − Diving mask 潛水器材-潛水面鏡 - 英文版 |
|
|
CNS 14881
- English Version Pliers and nIPpers for electronics - General technical requirements 電子用夾鉗與剪鉗試驗法 - 英文版 |
|
|
CNS 8975
- English Version Decarburized steel sheets and strIPs for porcelain enameling 琺瑯用脫碳鋼片及鋼帶 - 英文版 |
|
|
CNS 8576
- English Version Glossary of Terms Relating to Electric EquIPment for Automobiles (Relay, Breaker and Flasher System) 汽車用電器零件詞彙(電驛斷電器及閃光器系統) - 英文版 |
|
|
CNS 61496-2
- English Version Safety of machinery − Electro-sensitive protective equIPment − Part 2: Particular requirements for equipment using active opto-electronic protective devices (AOPDs) 機械安全-電敏式保護設備-第2部:使用主動式光電保護裝置(AOPD)之設備的特殊要求 - 英文版 |
|
|
CNS 11608
- English Version Unplasticized Polyvinyl Chloride PIPes with Fiberglass Reinforced Plastic Reinforcement 玻璃纖維強化塑膠加強聚氯乙烯塑膠硬質管 - 英文版 |
Translated |
|
CNS 15652-5
- English Version Intelligent lighting systems - Part 5: Lighting equIPment 智慧照明系統- 第5部:照明設備 - 英文版 |
|
|
CNS 15861-6
- English Version Method of test for feed lIPids – Determination of moisture and volatile matter content 飼料用油脂檢驗法-水分及揮發物含量之測定 - 英文版 |
|
|
CNS 11360
- English Version Cold-rolled steel strIPs for springs 彈簧用冷軋鋼帶 - 英文版 |
|
|
CNS 2958
- English Version Cast-iron PIPes and Fittings for Sanitary Equipments 衛生設備用鑄鐵管及管件 - 英文版 |
|
|
CNS 6349
- English Version Oil of peppermint (Mentha×pIPerita L.) 薄荷油 - 英文版 |
|
|
CNS 792
- English Version Basic Dimensions of 20 kgf/㎠ Ferrous Materials PIPe Flanges 鐵金屬製管凸緣基準尺度(20 kgf/㎠) - 英文版 |
|
|
CNS 15522
- English Version Safety of machinery - Two-hand control devices - Functional aspects and design princIPles 機械安全─雙手控制裝置─功能面與設計原則 - 英文版 |
|
|
CNS 15566-3
- English Version Safety of machinery – Pressure-sensitive protective devices – Part 3: General princIPles for design and testing of pressure-sensitive bumpers, plates, wires and similar devices 機械安全-壓敏保護裝置-第3 部:設計及測試壓敏緩衝器、板、線及類似裝置之一般原則 - 英文版 |
|
Find out:1329Items | To Page of: First -Previous-Next -Last | [6] [7] [8] [9] [10] [11] [12] |